Magnum MIG 208 Alu Synergy, Руководство пользователя

Страница: 12 / 24

12
If spot welding is off, briefly press the knob lower.
The symbol will flash together with the chosen option 2t and 4t.
The selection is done by turning the knob lower.
Approval followed by another short pressing the lower knob.
If the welder is turned on while working 4t display shows the
symbol
both in manual mode and
synergistic.
2t If it is on, the display does not show the above
symbol.
5.1 synergistic programs and settings.
After approval synergic mode, the display shows the current program and other parameters:
- the type of material chosen.
- wire diameter.
- shielding gas,
-
ATC (if the thickness of ≤1,5 ​​mm)
- material thickness,
-
wire feed speed.
- a graphic display of the shape and thickness of the weld material,
-
voltage and the current of welding (welding)
- on 4t.
To enter the menu you can select a type of material, wire diameter and shielding gas should push for no less than 2 seconds, lower the
dial until the symbols will appear as below. One of the symbols in the group
materials will blink. Rotating the bottom knob in either direction,
select the desired symbol of the material (no blink). Approval of
the selection is done by briefly pressing the lower knob.
Symbol will be displayed only the selected material (other
disappear), and starts blinking one of the accessible wire
diameters (diameters in the group). Analogously to the
previously lower, by rotation of the knob in either direction, set
the desired wire diameter.
Approval of the passage diameter and a group of shielding
gas takes place by briefly pressing the lower knob.
Then select the desired shielding gas lower knob by its rotation in either direction. Short pressing the lower
knob to confirm the selection and to exit the menu.
After leaving synergistic mode menu must adjust the welding, depending on the thickness of the welded part
- it is the upper switch.