Magnum MIG 208 Alu Synergy, Руководство по эксплуатации

Страница: 13 / 24

When this knob is turned to the right or left, the display will change the numerical value of the wire feed
speed, the material thickness in millimeters, and the graphic thickening or thinning of the material:
Depending on the material thickness selected, the ATC symbol will also appear.
ATC is an advanced thermal control function that is active when welding thin materials up to
1.5mm thick.
The ATC function stabilizes the electric arc and reduces the peak value of the welding current, reducing the
amount of heat transferred to the material. As a result, it significantly facilitates the welding of thin elements
and results in less deformation of the material, less overheating and a narrow heat-affected zone.
In turn, the lower knob is used to adjust the shape of the weld (arc length) in the range -9 ÷ 9.
The graphic symbol of the weld shape will change on the display:
Convex shape means low heat load with poor fusion into the material. Intermediate shape
is the recommended setting, with moderate penetration into the material.
The concave shape means a high thermal load with high fusion into the material.
LIST OF SYNERGY PROGRAMS
Material
Wire diameter [mm] Shielding gas
Fe - normal steels
0.6 / 0.8 / 1.0
WHAT
2 /
Ar + CO
2
Ss - stainless and acid-resistant steels 0.8 / 1.0 Ar + O
2 /
Ar + CO
2 (
1-2%)
Al - aluminum and aluminum alloys
CuSi, CuAl - braze welding
Flux - welding with cored wires
0.8 / 1.0
0.8 / 1.0
0.8 / 0.9 / 1.2
Ar
Ar
Ar *
Ar * - use the gas recommended by the wire manufacturer.
In the case of self-shielding wire, the use of shielding gas is not required.
13