
39
BE 58-602 Pulsar
®
Model R96 Radar Transmitter
3.3.2 Echo Rejection
Since all Non-Contact radar transmitters are
application/installation dependent, Echo Rejection
(ignoring false targets) is necessary.
The Model R96 transmitter Echo Rejection feature is
located in the DEVICE SETUP/BASIC CONFIG menu,
and requires the User Password to activate. It is highly
recommended that this feature be used with the waveform
capture capability of the Model R96 DTM and PACT
ware
™
.
Refer to Section 4.0 “Advanced Configuration/
Troubleshooting Techniques” or contact MAGNETROL
Technical Support for additional instructions.
3.3.3 Volumetric Capability
Selecting Measurement Type = Volume and Level allows the
Model R96 transmitter to measure volume as the Primary
Measured Value.
3.3.3.1 Configuration using built-in Vessel Types
The following table provides an explanation of each of the
System Configuration parameters required for volume
applications that use one of the nine Vessel Types.
Configuration Parameter
Explanation
System Units
A selection of Gallons, Barrels, Milliliters, Liters, Cubic Feet, or Cubic Inches, is provided.
Vessel Type
Select either Vertical/Flat (factory default Vessel Type), Vertical/Elliptical, Vertical/Spherical,
Vertical/Conical, Rectangular, Horizontal/Flat, Horizontal/Elliptical, Horizontal/Spherical,
Spherical, or Custom Table.
Note: Vessel Dims is the next screen only if a specific Vessel Type was selected. If Custom Table
was selected. Refer to page 48 to select the Cust Table Type and Cust Table Vals.
Vessel Dims
See the vessel drawings on the following page for relevant measuring areas.
Radius
Used for all Vessel Types with the exception of Rectangular.
Ellipse Depth
Used for Horizontal and Vertical/Elliptical vessels.
Conical Height
Used for Vertical/Conical vessels.
Width
Used for Rectangular vessels.
Length
Used for Rectangular and Horizontal vessels.
MEASUREMENT TYPE = LEVEL & VOLUME