Flex Pro Transmitter Instruction Manual
April 2019
Cranes, hoists, lifting devices and other material handling equipment can be large and can operate at high
speeds.
The operator should:
•
continuously watch and monitor status of lifted loads
•
know and follow cable and hook inspection procedures
The operator shall not:
•
lift or move more than the rated load
•
use the crane, hoist or lifting device to lift, support or transport people
•
lift or carry any loads over people
•
operate the crane, hoist or lifting device unless all persons, including the operator, are and remain
clear of the supported load and any potential pinch points
•
operate a crane, hoist or lifting device when the device is not centered over the load
•
operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the
sprockets, drum or sheave
•
leave any load unattended while lifted
2.11 Specific System Warnings
The following specific operating safety tips should be strictly followed when operating a Flex Pro system:
•
Check the Status LED on the transmitter for any signs of low battery power (
Status Lights Indicators and Warnings on page 22
•
Check the Status LED on the transmitter for any signs of irregularities (
Lights Indicators and Warnings on page 22
•
Make sure the system is not set to the same channel as any other Flex systems in use within a
distance of 300 meters (900 feet).
•
Never operate equipment with two transmitter handsets at the same time unless they are
programmed for such use.