RS 350 M / RS 400 M / RS 500 M / RS 350 MW / RS 400 MW / RS 500 MW
EN
www.magmaweld.com
16
USER MANUAL | MANUAL DO UTILIZADOR | KULLANIM KILAVUZU
Installation Information
2.3 Mains Plug Connection
2.4 Welding Connections
For your safety, never use the mains cable of the machine without a plug.
Be sure that the connections are fastened tightly. Loose or incorrect fastening may cause overheating or gas leakage.
• No plug has not connected to the mains cable since there may different types of
outlets available in plants, construction sites and workshops. A suitable plug
must be connected by a qualified electrician. Make sure that the grounding cable
marked with a yellow / green color is present.
• AFTER CONNECTING THE PLUG TO THE CABLE, DO NOT ATTACH IT TO THE OUTLET AT
THIS STAGE.
Figure 5: Power Plug Connection
Figure 7: Connections of the Wire Feeding Unit, the Water
Cooling Unit and the Earth Clamp for RS 350 MW,
RS 400 MW and RS 500 MW
Figure 6: Connections of the Wire Feeding Unit and the
Earth Clamp for RS 350 M,
RS 400 M and RS 500 M
• Place the wire feeder on to the turn table on the machine.
• Connect the blue gas hose
(16-c)
to gas outlet bush in front of the power source.
• Connect the control cable
(16-b)
to the control socket in front of the power source.
• Connect the welding plug
(16-a)
into the welding cable connection outlet in front of the power source.
• Connect the earth cable to one of the earth clamp sockets on the power source very tight.
• Sockets with different inductance values help the machine to weld with less spatter at a wider current range. For the smaller currents or wire
diameters the socket should be chosen, for the bigger currents and wire diameters use the socket or .
• To increase the quality of the welding, earth clamp should be clamped tightly on the workpiece, as close as possible to the welding area.
2.4.1 Connections of the Wire Feeder
2.4.2 Connections of the Earth Clamp
