EN
www.magmaweld.com
RS 350 M / RS 400 M / RS 500 M / RS 350 MW / RS 400 MW / RS 500 MW
19
USER MANUAL | MANUAL DO UTILIZADOR | KULLANIM KILAVUZU
3.3 Wire Feeding Rolls Selection And Change
• Open the cover of the wire feed section. You will see the 4-roller wire feed system.
• Use wire feeding rollers suitable for the material and diameter of the welding wire you are going
to use. Use V-ribbed rollers for steel and stainless steel, V-ribbed serrated rollers for cored wire,
U-ribbed rollers for aluminum.
• If you need to replace the wire feeding rollers, pull the pressure roller lever towards you and lift
the pressure rollers , then unscrew the wire feeding rollers and remove the existing rollers
(Figure 17).
• After inserting the rollers to be used, re-install the screws and lower the pressure rollers and lift
the pressure roller lever and lock it onto the print rollers (Figure 18).
44-
Motor
45-
Euro Connector
46-
Pressure Rolls Handle
47-
Pressure Rolls
48-
Wire Feeding ( W.F.) Rolls
49-
W.F. Rolls Screws
Figure 16: Wire Feeding System
Figure 17: Removing the Wire Feeding Rolls
Figure 18: Installing the Wire Feeding Rolls
Both sides of the rollers are marked according to the wire diameter in which they are used. Place the reels on the
flange so that the wire diameter you will use is on the side facing you.
Usage Operation
