1-800-MAGLINE (624-5463)
Page 4 www.magliner.com
CooLift
®
VERTICAL LOOP HANDLE REMOVAL
TOOLS NEEDED:
TORX T30 DRIVER, #3 PHILLIPS SCREWDRIVER 7/16” WRENCH
Note: It is important to keep the CooLift upright at all times.
1) Remove the brake master cylinder using the T30 driver and place it on the top shelf of the user
end cabinet. NOTE: It is not necessary to remove the brake line.
2) Remove the mounting screws (4 upper, 4 lower)(K, I) that connect the vertical loop handles using
#3 Phillips screwdriver and 7/16” wrench. For the CTA48 model, set aside the bulk head mounting
brackets.
3) Remove the two screws (F) that mount the horizontal brace (E) to each of the vertical loop
handles (A, D) using the #3 Phillips screwdriver and the 7/16” wrench.
4) Rotate each of the vertical loop handles (A, D) toward center in order to allow the handles to clear
the upper handle mounts (see illustration for screw locations and handle rotation).
5) The handle assembly consisting of a left and right vertical loop (A, D) and a horizontal brace (E)
should be able to be removed by grasping the entire assembly on both sides at the junction of the
horizontal and vertical components and lifting in an upward motion.
VERTICAL LOOP HANDLE REPLACEMENT
TOOLS NEEDED:
TORX T30 DRIVER, #3 PHILLIPS SCREWDRIVER 7/16” WRENCH
Note: It is important to keep the CooLift upright at all times.
NOTE: Replacing a handle on the CooLift requires that the entire handle assembly first must be
removed. See Vertical Loop Handle Removal for instructions.
1) With the entire handle assembly removed from the CooLift, slide the vertical loop handle to be
replaced out of the horizontal handle grip mount.
2) Slide the replacement handle into place taking care to minimize scratching or marking on the
aluminum tubing.
3) Grasp each of the vertical loop handles (A, D) by the foam section and rotate the top looped
portion of each section towards the other.
4) Place the base of the handle assembly on top of the cabinet such that the bottom of the vertical
loop handles are located within the arc of the end caps on each of the corner posts and rotate the
top of the vertical loop handles outwardly into position.
5) Place the two screws (K) into holes located within the top section of the vertical loop handles
and then hand tighten it to the frame. For the CTA48 model, be sure to replace the previously
removed bulk head mounting brackets.
6) Place the screws (I)
into the holes located in the lower section of the vertical loop handles and
hand tighten them to each of the corner posts.
7) Place the remaining two screws (F)
in the holes that secure the horizontal brace (E) to each of the
vertical loop handles (A, D) and tighten them using #3 Phillips screwdriver and 7/16” wrench.
8) Tighten the remaining previously hand tightened screws with #3 Phillips screwdriver and 7/16”
wrench.
9) Position the master cylinder (J) into place on the horizontal brace (E) and tighten the two mounting
screws with the Torx T30 driver.
