1-800-MAGLINE (624-5463)
Page 12 www.magliner.com
CooLift
®
REPLACING VERTICAL HANDLE MOUNT ASSEMBLY
TOOLS NEEDED:
7/16” WRENCH, 1/2” WRENCH, #3 PHILLIPS SCREWDRIVER
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface with the holding brake engaged.
2) Turn off main power switch.
3) Remove the bulk head (see Bulk Head Removal).
4) Remove vertical loop handles (see Vertical Loop Handle Removal).
5) If you have a CTA48 model, remove the bulk head mount brackets using the #3 Phillips head
screwdriver and the 7/16” wrench.
6) Remove the battery box (see Replacing Battery Box for proper removal).
7)
Remove the ten screws - five on each side - that connect the vertical handle mount assembly to
the CooLift. Use the #3 Phillips head screwdriver and the 7/16” wrench on the top three screws
(B, D)
and the #3 Phillips head screwdriver and the 1/2” wrench on the bottom two screws (C) on
each side.
8) Grasp the vertical handle mount assembly (A) to be replaced and lift it straight up to remove it
from the cart.
9) Position the new vertical handle mount assembly (A) into place and secure with the previously
removed screws and nuts and tighten with the #3 Phillips head screwdriver and the 7/16” wrench.
10) Replace the battery box (see Replacing Battery Box instructions for proper installment).
11) Reconnect the handle (see Replacing Vertical Loop Handle).
12) If replacing the assembly on the CTA48 model, reinstall the bulk head mount brackets using the
#3 Phillips head screwdriver and the 7/16” wrench.
13) Reinstall the bulk head (see Installing Bulk Head).
A
B
C
Item
Qty
Part Number
A Vertical handle mount assembly
1
309087
B Screw - 1/4”-20 x 2-1/2” long
2
80108
C Screw - 5/16”-18 x 1-1/2” long
2
80115
D Screw - 1/4”-20 x 1-1/2” long
1
80105
D
Hardware quantities listed are for one side of the CooLift
CTA48 bulk head
mounting brackets
(2 per side)
