Page 37
3.10.1. Continuation of Installation - Remote Control
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Feed the cable from the receiver unit
heat shield to the spade terminals on the
control valve, keeping the cable clear of
the underside of the tray. The cable
connectors must be matched to the
appropriately sized spade connector.
4. Position the receiver under the heat
shield as shown in
Figure 61
.
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (
Sections
2.1.3
or
2.1.5
on
pages
8 or 10
).
6. Proceed to
Section 3.10.4
to
commission the installation.
Heat
Shield
Receiver
Figure 61
Содержание Premos 18" Inset
Страница 8: ...Page 4 This page is left intentionally blank...
Страница 20: ...Page 16 Large Random Coals Figure 27 Small Random Coals Figure 28...
Страница 39: ...Page 35...
