MAGIC FX PSYCO2JET, Руководство пользователя и инструкция по установке

Страница: 10 / 40

10 MAGICFX
®
PSYCO2JET — User and Installation Manual
Operating of the addresses in RAW mode results in the following:
DMX Address DMX Value (decimal) Result
Safety address
0 99 Device disabled
100 155 Device enabled
156 255
Device test mode (CO
2
output is disabled)
Start address (Angle)
0 126 -90° to -0.7°
127 128 Center position
129 255 +0.7° to +90°
Start a 1 (Speed) 0 255
Minimal speed -> Full
speed
Start a 2 (Output)
0 199 Valve off
200 255 Valve on
Operation of the DMX addresses in RAW mode
When you link multiple machines with DMX, we advise you to use the same Safety
address for all machines.
CAUTION
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
1.7 PRESET MODE
In PRESET mode, the operator controls the output of the MAGICFX
®
PSYCO2JET with the
help of one of the preprogrammed presets. With DMX the operator controls the
following variables:
• The selected preset
• The speed of rotation of the output pipe
• The directions of the output pipe
• The ´Go´ mode:
• OFF (No movement)
• Continuous (The preset is repeated continuously)
• Step in preset (Step by step)
PRESET mode is selected from the operator menu. Check Section 1.5 for the menu
structure.
The MAGICFX
®
PSYCO2JET is programmed with 10 presets. Each preset is a unique
sequence of pulses and/or sweeps of CO
2
, see figures.