Maeda MC-174CRM, Руководство по эксплуатации

Страница: 199 / 276

4-27
[3] OIL REPLACEMENT IN ENGINE OIL PAN
• Make sure the oil level gauge is secured properly after inspection and replenishment of the oil.
Potential fall of the oil level gauge during operation may occur if disregarded, which could
cause boiling oil to gush resulting in burns.
• All the parts will be at elevated temperatures immediately after engine operation, which urges
you not to replace oil. Always perform replacement with the engine cold to touch.
CAUTION
• Be sure to use oil specified in section 5.1 “Use of Lubricating Oil according to Temperatures”
in Inspection and Maintenance. Failure to use proper oil may cause the engine to shorten its
useful life. Always use the specified oil for replenishment.
• The engine oil level must be maintained at the proper amount.
• The complete draining of oil is disabled if the engine becomes cold completely. Oil draining is
allowed when the engine is cold to touch.
• Keep impurities out of the filler cap when replenishing oil.
•
Oil drain pan: A 2-litre container
•
Quantity of oil for replacement: 1.2 litres
1. Place the machine on a level surface.
2. Place a drain pan directly underneath the drain plug (P) at the
bottom of the machine left side to receive drained oil.
3. Remove the drain plug (P) slowly to drain the oil, keeping from
contact with draining oil.
4. Check the drained oil. If check finds a considerable amount of
metal powder and foreign objects, contact us or our sales
service agency.
5. Put in the drain plug (P) and secure it.
6. Pull the oil level gauge (G) out and wipe the oil with a disposable
cloth.
7. Refill the engine oil to the specified level, from the port where the
oil level gauge was attached. When the oil is refilled to near the
mouth of the port, the specified level is achieved.
8. Insert the oil level gauge (G) into the oil filler and pull it out.
NOTES
Don't screw in the oil level gauge (G).
That causes oil to be filled higher than correct level.
9. Make sure the oil level is in the range
“H” to “L” marked on the oil
level gauge (G).
10. After oil replacement, securely install the oil level gauge (G).