Maeda MC-174CRM, Руководство по эксплуатации

Страница: 188 / 276

4-16
[REMOVAL WINCH WIRE ROPE]
Use the following procedure to remove the wire rope.
1. Place the machine on a level and solid surface.
2. Place the boom telescoping lever in the “Extend” position (push
forward) to extend the boom slightly.
3. Place the winch lever in the “Down” position (push forward) to
lower down the hook block to the ground.
4. Undo the wedge socket fixing bolt (2) and remove the wedge
socket (3).
5. Remove the wire clip (4).
6. Pull the wire rope (5) out of the wedge socket (3), following the
procedure provided below.
(1) Bring a 4 to 6mm round bar (6) into contact with the rope
wedge (7).
(2) Remove the rope wedge (7), lightly tapping the round bar (6)
with a hammer in the direction indicated by the arrow (a).
7. Place the winch lever in the “Down” position (push forward) to
wind up the wire rope (5) from the winch drum.
8. With the wire rope wound off from the winch drum, detach the
end of the wire rope (5) from the winch drum (8) by following the
procedure provided below.
(1) Bring a 4 to 6mm round bar (6) into contact with the rope
wedge (9).
(2) Remove the rope wedge (9), lightly tapping the round bar (6)
with a hammer in the direction indicated by the arrow (b).
9. Wind off the remaining wire rope (5) completely.
Removal of the winch wire rope is completed.