Maeda D3001, Руководство по эксплуатации

Страница: 171 / 294

M A E D A Mini-Crawler Crane Section 4 – REMOTE CONTROL OPERATION
3/2019 MC305C-3 4-107
Operation in Outrigger Mode
WARNING!
• Check smooth and correct actions of each
operation lever of the Transmitter, and they
smoothly return to each neutral position
when the finger is released.
• Each operation lever of the Transmitter will
be blocked by its stopper when it is moved
full. When it is blocked, do not attempt to
push more, otherwise it may damage the
Transmitter to cause its fault and results a
serious accident.
• To toggle each operation lever to the
opposite side, or to use another lever,
always release the Accelerator lever, each
time. Also, to operate the outrigger,
manipulate the operation lever first, then
pull the Accelerator lever. To stop the
actuation of outriggers, release your finger
from the Accelerator lever, first, then
discharge the operation lever.
• For the outrigger operations, always keep
the engine speed in the low or middle
range. Such operation in the high speed
range makes outriggers actuate too
quickly, which may tip the Crane and result
in a serious hazard.
• For the outrigger operations, always
configure the Crane to the stow position. In
the condition that the boom is raised or
any load is craned, it may cause a serious
accident, such as tipping of the Crane.
• For the outrigger operations, always
ensure that the position pin of each
outrigger is securely inserted. In the event
where the pins are missing, the Crane may
be tipped and it results in a serious hazard.
• For the installation of outriggers, always
extend them first in the "Extension mode",
then switch the mode to "Ground setting
mode". Lift each outrigger equally and
gradually, until the Crane is properly
elevated. For the stowing of Outriggers,
lower each outrigger equally and gradually,
until the Crane is grounded in the "Ground
setting mode", then switch to the
"Extension mode" to retract them.
Unless otherwise this order is followed,
that may cause to tip the Crane and bring a
serious accident.
1. Ensure that the Main switch of the Receiver
is in the OFF position.
2. Start the engine by the Starter switch of the
Crane.
3. Push the Power switch of the Transmitter to
power ON.
Confirm that the LCD screen shows the
mark as the figure and the "CRANE MODE"
is automatically provided.
Fig. 4-315
4. Then turn ON the Main switch of the
Receiver.
Fig. 4-316
NOTICE: When the Main switch of the Receiver
is turned ON, the abnormal signal detector
circuit works for 3 to 4 seconds. During this
moment, the Crane is not ready for operations.
NOTICE: This Crane equips four sets of
outriggers and number labels (1) to (4) are
appended on each. These labels correspond to
the number of each operation lever in the
Transmitter. (See the figure.)
•
•
•
•
•
•
•
•
•
Fig. 4-317