Maeda D3001, Руководство по эксплуатации

Страница: 212 / 294

Section 5 – GENERAL MAINTENANCE INFORMATION AND PRECAUTIONS Mini-Crawler Crane M A E D A
5-8 3/2019 MC305C-3
19B
Check the Service Meters
Read the service meters daily to check for any
maintenance item that reached the obligatory
maintenance period.
20B
Use Genuine Parts for
Replacement
Always use Maeda genuine parts as specified in
the parts catalogue for part replacement.
21B
Use Pure Grease
Always use Maeda pure grease. The viscosity of
grease must conform to specifications according
to ambient temperature.
22B
Use Clean Oil and Grease
Always use clean oil, grease, and container to
keep impurities out of them.
23B
Keep the Machine Clean
Keep the machine clean to facilitate the detection
of a malfunction. Especially keep the grease
nipple, breather, and oil level gauge (oil access
door) clean to prevent impurities from finding their
way into the machine.
24B
Handle Water and Oil at Adequate
Temperature
Drainage, drain oil, and exhaust filter will be at
elevated temperatures immediately after the
machine comes to a stop. Replace drainage, drain
oil, and filter only after they drop in temperature for
safety.
If the oil is cold, raise the temperature of the oil to
approx. 20 to 40°C.
25B
Check Drain Oil and Oil Filter
For replacement of oil and filter, check the drain oil
and exhaust filter to make sure no a considerable
amount of metal powder or foreign objects is
present.
26B
Cautions for Lubrication
Do not remove the strainer to lubricate if it is
attached to the lubrication opening.
27B
Protect Oil from Impurities
Avoid dust when inspecting and replacing the oil
to keep impurities out of the oil.
28B
Attach a Warning Tag
When draining coolant and oil, always attach a
warning tag to the travel control for the prevention
of accidental engine starting.
29B
Follow Safety Precautions
Safety precautions provided on the machine
should always be followed when using the
machine.
30B
Cautions for Weld Repair
• Power off the machine. (Turn OFF the start
switch)
• Do not continuously apply 200V or greater.
• Ground the machine within 1 metre from the
welding point.
• Be sure to disconnect the connectors of the
radio or remote control system, moment limiting
indicator, and moment limiting converter.
• Remove the negative terminal (-) of the battery.
• Make sure no sealing or bearing is present
between the welding point and the grounding
point.
Potential damage to sealing may occur due to
sparks if disregarded.
• Do not ground around the boom pin or the
hydraulic cylinder.
Potential damage to a plated section may occur
due to sparks if disregarded.
31B
Keep from Flame
Always clean the parts with noncombustible
cleaning agent or light oil.
Keep the machine from flame when using light oil.
32B
Keep the Attachment Surface
Clean
Be sure to clean the attachment surface after
removing a part to which the O-ring and gasket
sealing are attached.
Replace the part with a new one with the O-ring
and gasket reattached.
33B
Empty Your Pockets
Always empty your pockets before performing
inspection and maintenance of the machine in a
downward direction with the cover opened.