IMPLEMENTATION
21 / 30
3.2.1.1.Pre-identification mode
A pre-identification sensor for all type of cable.
Mode only usable with a transmitter in S1 mode or two transmitters in
S1 and S2 mode.
Connect the sensor to the receiver, the pre-identification
light illuminates.
Place the sensor on the cable, so that the groove under the
sensor fits around the cable.
Press the « measurement » button, the «
end of
measurement
» light turns off.
Wait for the result (6 seconds) without moving the sensor,
the «
end of measurement
» light illuminates and if the
cable is pre-identified, then the YES LED illuminates.
If the cable is not pre-identified, repeat the operation on
other points of the cable with 10cm of distance between
them.
If the answer is YES, it is always good to confirm this by
repeating the measurement at several points along the
cable.
The receiver indicates by « YES » the identification of the cable.
