IMPLEMENTATION
16 / 30
It is better to place the current clamps before starting the transmitter.
If not, opening the clamps during transmitter causes the clamp fault
lights to illuminate.
L1 L2 L3
L1 L2 L3
L1 L2 L3 N
N L1 L2 L3
HTA
BT 4 conducteurs
3.1.3.Precautions for using the transmitter
THE CURRENT CLAMPS MUST ALL HAVE THE SAME
ORIENTATION WITH RELATION TO THE CABLE END (Indicated
by the arrows on the clamps).
CHECK THAT THE CLAMPS ARE ON AN UNSCREENED LENGTH
OF CABLE. IF NECESSARY, USE WOODEN CLAMPS OR TAPE TO
HOLD THEM IN POSITION.
TO AVOID RISK OF ERROR IN CABLE DESIGNATION, USE ONLY
ONE TRANSMITTER ON A SITE.
AFTER TURN-ON, CHECK ON THE FRONT FACE:
THAT THERE ARE NO TRANSMISSION CIRCUIT FAULTS
THE BATTERY CHARGE LEVEL
