IMPLEMENTATION
20 / 30
3.2.1.Use of receiver
Connecting a sensor to the Receiver automatically sets the operating
mode which is indicated by a LED.
These modes are:
• Continuity and Identification in short-circuit
• Continuity and Identification in open-circuit
• Pré-identification
One press of the «
Measurements
» button turns on and illuminates
the LED corresponding to the mode selected by the chosen sensor,
which confirms to the operator the type of measurement to carry out.
After 30 seconds with no press of the «
Measurements
» button, the
Receiver switches off until a new button press.
If there is no sensor connected, one press on «
Measurements
»
button illuminates during 1 second all LEDs to be sure they are all
operational.
Certain modes are only available when the Transmitter is in S1 mode
or when two Transmitters, one in S1 mode and the second on S2
mode are connected to the ends of the same cable. A transmitter in S2
mode only does not allow core identification in open-circuit or short-
circuit. This kind of utilization automatically appears when two
transmitters in S1 and S2 mode are connected to the same cable and
that this cable is cut after pre-identification.
