Page
54
of
63
Refitting / Replacement
Step 9 - Refitting is a reversal of the removal process noting the following point:
A)
While reinserting the Traverse Shaft, you must one by one, align the spacers and Idle
Gear to allow the Traverse Shaft to pass through
B)
The LONGER Spacer (37.1mm
–
use Vernier calliper to measure) + (Number 3 in the
image above) will be aligned first as shown.
C)
Then the Idle Gear must be fitted to the Traverse Shaft as shown
D)
Align the SHORTER Spacer (34.3mm), then slide the Traverse Shaft all the way through
the Chassis and into the Bush in the opposite Chassis Wall
E)
Use long noise pliers to reattach the 8mm E-Clip onto the Traverse Shaft
Содержание TX440 Advanced PT
Страница 10: ...Page 10 of 63...
Страница 11: ...Page 11 of 63...
