Page
47
of
63
9.12.2
Charging Beak
–
Track Type 2, 3, 4, 5 and Powered
Auxiliary
Within this section it will explain the correct procedure on removing and reinstalling the
Charging Beak for servicing procedures or replacement.
Removal
Step 1 - Remove external covers off the Hoist. (refer to section 9.1)
Step 2
–
Remove the Battery from the battery brackets. (Refer to section (9.3)
Step 3
–
Disconnect the Charging Beak from the PCB.
Step 4
–
Reroute the Wire from under the Battery Bracket.
Step 5
–
Cut the cable tie that secure the wire to the Chassis.
Step 6
–
Using a Pozi Screwdriver, remove the screws to release the Charging Beak.
Refitting / Replacement
Step 7 - Refitting is a reversal of the removal process noting the following point:
A)
One cable tie is required!
–
Re-secure the Wire with cable tie as instructed below:
Pass through the cable tie (100x2.5mm) through the hole and tie to secure the wire to the
chassis. Snip the surplus cable once secured.
Содержание TX440 Advanced PT
Страница 10: ...Page 10 of 63...
Страница 11: ...Page 11 of 63...
