MULTI-CHANNEL ANALOG MIXERS WITH ENHANCED FX, USB RECORDING MODES, AND BLUETOOTH®
38
From here, rotate the knob again to tweak the selected parameter’s value to your liking. Once a desired setting has been
reached, push the knob in again to confirm.
Frequency
– This parameter’s value determines the frequency of the selected effect, ranging from 400 Hz to 16.0 kHz.
Width [aka “Q”]
– The Q control adjusts the bandwidth of a filter. However, the Q value itself is dimensionless; it has no unit
of measurement. Some equalizers use the fractional bandwidth of the filter, measured in octaves, to express this parameter.
The two parameters are inversely related; a high Q value corresponds to a small fractional bandwidth. The following table
lists some equivalent Q and fractional bandwidth values. It ranges from 0.5 to 3.
Gain
– This parameter’s value determines the amount of gain applied to the selected effect. It ranges from –8 dB to +8 dB.
LPF
– Low-pass filters are utilized to cut out high frequencies. It ranges from 6.0 kHz to 18.0 kHz.
HPF
– High-pass filters are utilized to cut out low frequencies. It ranges from 80 Hz to 600 Hz.
Before moving on to ‘Presets’ and ‘Reset’, let's take a quick peek at the parameters of delay, echo and slapback,
as well as their EQ settings.
Delay Parameters and Values
Q
Bandwidth
(Octave)
0.7
2
1.414
1
2.145
2/3
2.871
1/2
Parameter
Low Value
High Value
Default
Increments
Time
20 ms
1000 ms
363 ms
±~10 ms
Feedback
0
13
2
±1
Hi Cut
0
100
78
±1
EQ
–
–
–
–
Frequency
400 Hz
16.0 kHz
7.9 kHz
Variable
Width (Q)
0.5
3.0
0.5
±0.1
Gain
–8 dB
+8 dB
+1 dB
±1 dB
LPF
6.0 kHz
18.0 kHz
6.0 kHz
±0.1-0.2 kHz
HPF
80 Hz
600 Hz
120 Hz
±1-10 Hz