MacDonald Steel Limited
BREWERY SYSTEMS DIVISION
19
REV 00
MENU EXPLAINATIONS
3. EZ Setup
Level Off/On
This button is used to turn the auto level detection off or on. When the level detection is ON, the head will
automatically detect the proper level and shut off the beer valve. If the head will not detect the level the
setting may be turned to OFF. When the level is turned off the stop switch for that head must be used to
turn off the beer valve. Consult the troubleshooting section of this manual for reasons the level detection
may not be working. The default is set to ON upon power up.
Level Delay
This timer is used to delay the beer valve from shutting off once the level has been detected. By
increasing the delay time the fill height in the bottle can be increased. The amount of increase is
determined by the flow rate as this is a timer.
CAUTION: Too much delay time will cause product to flow out of the bottle and into the vent line. This
will cause foaming in the next fill cycle as the excess beer is blown back into the bottle during the purge
cycle. This in turn will result in the head "bridging" or shorting out the level detectors. Under normal
operating conditions set this value to "0". If you cannot achieve the proper level required for your style
bottle you may need to change the length of the vent tube. Contact MacDonald Steel for assistance.
Simultaneous or
Sequential Filling
Auto Level On/Off
Enable/disable head
Shuttle On/Off
Often used for can
filling.
Crowner On/Off
1-5 Purges
Purge
Timeout
Quick Pressure Setup
Crowner Time
Auto Level
Delay Time
