215026
151
Revision A
Changing conditioner roll timing gearbox oil:
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine: stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine.
1028283
A
B
Figure 4.161: Roll Timing Gearbox
8.
Raise the header to provide sufficient access to oil drain
plug (A).
9.
Shut down the engine, and remove the key from the
ignition.
10. Engage the windrower lift cylinder safety props. For
instructions, refer to
3.2.1 Engaging and Disengaging
.
11. Clean around oil drain plug (A) on the bottom of the
gearbox and around oil level plug (B) on the inboard side of
the gearbox.
12. Place a 1 liter (1.05 qts [US]) container underneath the
conditioner gearbox.
13. Remove oil drain plug (A) using a hex key.
14. Allow sufficient time for the oil to drain, reinstall oil drain
plug (A), and tighten.
15. Fill with the specified volume of oil as listed on the inside
back cover of this manual or until level is visible in sight
glass (B).
16. Reinstall driveshields. For instructions, refer to
Installing Driveshields, page 166
17. Lower the header fully.
18. Properly dispose of oil.