262175
37
Revision A
1020058
A
B
C
D
Figure 3.36: Anti-Shimmy System
–
Left Side
15. Secure the barrel end of anti-shimmy dampener (A)
(MD #202898) to the forward hole in support (B) with one
M16 x 75 bolt (C) (MD #181511) and one M16 nut (D)
(MD #152520). Install the bolt from under the support. Do
NOT
fully tighten the hardware yet.
1020059
A
B
C
D
Figure 3.37: Anti-Shimmy System
–
Left Side
16. Secure the barrel end of second anti-shimmy dampener (A)
(MD #202898) to support (B) at the aft hole location with
one M16 x 90 bolt (MD #252533) and M16 nut (C)
(MD #152520). Install the bolt from under the support. Do
NOT
fully tighten the hardware yet.
17. Rotate the caster so that arm (D) is aligned with the
walking beam.
1016210
A
C
B
D
Figure 3.38: Anti-Shimmy System
–
Left Side
18. Attach the rod ends of the anti-shimmy dampeners to the
arm with M16 x 90 bolt (A) (MD #252533) and three
hardened washers (B) (MD #120901).
NOTE:
Washers (B) are stamped with
“
L9
”
.
19. Torque bolt (A) to 244 Nm (180 lbf·ft).
20. Install jam nut (C) (MD #136473). Torque the nut to 138 Nm
(102 lbf·ft).
21. Tighten bolts (D) at the barrel end of the anti-shimmy
dampeners. Torque the nuts on bolts (D) to 138 Nm
(102 lbf·ft).
IMPORTANT:
Ensure that the arm remains parallel to the walking beam
while the hardware is tightened. Do
NOT
overtighten the
hardware.
22. Repeat Step
to Step
to install the
anti-shimmy system on the opposite side of the windrower.
Содержание M2170
