MacDon M2170, Инструкции по разгрузке и сборке

Страница: 197 / 266

262175
189
Revision A
IMPORTANT:
Install caps and plugs on open lines to prevent the buildup of dirt and debris.
1. Clear all bystanders from the area.
1022749
A
Figure 5.203: GSL
2. Start the engine, and press HEADER UP button (A) on the
ground speed lever (GSL) to raise the header to maximum
height.
3. If one end of the header does NOT rise fully, rephase the
cylinders as follows:
a. Press and hold HEADER UP (A) switch until both
cylinders stop moving.
b. Continue to hold the switch for 3
–
4 seconds. The
cylinders are now phased.
4. Shut down the engine, and remove the key from
the ignition.
1029808
A
Figure 5.204: Safety Prop Lever
5. Engage the safety props on both lift cylinders as follows:
a. Pull lever (A) toward you to release it, then rotate it
toward the header to lower the safety prop onto the
cylinder.
b. Repeat the previous step for the opposite lift cylinder.
IMPORTANT:
Ensure that the safety props engage over the cylinder piston
rods. If the safety prop does
NOT engage properly, raise the
header until the safety prop fits over the rod.
1030516
A
B
C
Figure 5.205: Header Supports
6. Remove hairpin (A) from clevis pin (B). Remove the clevis
pin from header support (C) on both sides of the header.
ATTACHING HEADERS TO WINDROWER