MacDon M105, Руководство оператора

Страница: 189 / 384

OPERATION
1. Engage header.
2. Set HEADER INDEX switch (B) to
OFF.
3. Press DISPLAY SELECTOR (E) to display at (A)
DRAPER SPEED.
4. On cab display module (CDM) press
FAST
(C) or
SLOW
(D) until desired draper speed is displayed at (A).
Display shows
##.# DRAPER SPEED.
##.# = MPH or KPH
4.6.8 Knife Speed
The ideal cutting speed of the knife should be such that a clean cut is achieved. Crop types and conditions
usually in
fl uence the knife and forward speeds. Refer to the header operator’s manual for more information
on knife speeds.
The knife speed is manually set by making adjustments to the knife drive pump, and has been preset at the lowest
knife rpm. For optimum performance, adjust the knife speed according to the header being used. Refer to the
following table.
If the machine is equipped with the appropriate sensor and optional module, the cab display module (CDM) will notify
you when the knife speed reaches an overload preset (usually 75% of knife speed).
The preset can be changed on the CDM. Refer to
3.18.5 Cab Display Module (CDM) Programming, page 70
.
NOTE:
The knife speed should be set within the range speci fi ed for each header.
Table 4.1 D-Series Knife Speed
Header Description Knife Speed
Minimum Maximum
Type Size (ft)
rpm
14
spm
15
rpm
14
spm
15
15 750 1500 950 1900
20 and 25 700 1400 850 1700
30 800 1600
Draper Double
Knife
35 700 1400
20 and 25 750 1500
30
600 1200
Draper Single
Knife
35 550 1100
700 1400
Setting Knife Speed (with Expansion Module MD #4666)
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
14. Revolutions per minute - Speed of knife drive box pulley
15. Strokes per minute of knife (rpm x 2)
169890
175
Revision A