215620
190
Revision A
•
Changing the header drive pump associated with the knife drive, Harvest Performance Tracker (HPT), or the master
controller on the windrower
For instructions, refer to
5.7.1 Calibrating Knife Drive on Harvest Performance Tracker Display, page 230
and
Calibrating Header Position Sensors on Harvest Performance Tracker Display, page 233
.
5.4.4
Detaching R1 Series Rotary Disc Header
Detaching an R1 Series header from an M1 Series windrower requires removing the electrical and hydraulic connections,
detaching the header supports, and releasing the center link.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
DANGER
Ensure that all bystanders have cleared the area.
$
Figure 5.155: GSL
1.
Start the engine.
2.
Press switch (A) to raise the header to its maximum height.
3.
Shut down the engine, and remove the key from
the ignition.
$
Figure 5.156: Safety Prop Lever
4.
Engage the safety props on both lift cylinders as follows:
a.
Pull lever (A) toward you to release it, and then rotate
it toward the header to lower the safety prop onto the
cylinder.
b.
Repeat the previous step for the opposite lift cylinder.
IMPORTANT:
Ensure that the safety props engage over the cylinder piston
rods. If the safety prop does
NOT
engage properly, raise the
header until the safety prop fits over the rod.
