214143
20
Revision F
1017836
A
Figure 4.7: Optional Two-Sensor Kit
–
Right Sensor
10. Using a voltmeter, measure the voltage between the
ground (Pin 2) and signal (Pin 3) wires of AHHC sensor (A)
at the back of the side frame. Ensure it is at the low voltage
limit for the combine.
NOTE:
The wiring harness connector must be attached to the
sensor. Do
NOT
disconnect it.
11. If the sensor voltage is not within the low and high limits,
or if the range between the low and high limits is
insufficient, adjust the voltage limits. For instructions, refer
to
.
12. Repeat at the opposite side.
