169441
234
Revision D
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
3.10.1 Engaging Reel Safety Props, page 36
5.
If replacing only the cam end bushing, proceed to Step
.
Removing center disc and tail-end bushings
ϭϬϰϬϭϵϯ
A
B
Figure 4.228: Reel Arm
6.
Remove bolts (A) securing arm (B) to the disc at both
locations.
IMPORTANT:
Note the hole locations in the arm and disc, and ensure
bolts (A) are reinstalled at the original locations.
1001283
A
Figure 4.229: Bushing Clamp
7.
Release bushing clamps (A) using a small screwdriver to
separate the serrations. Pull the clamp off the tine tube.
1004617
A
B
Figure 4.230: Bushing
8.
Rotate arm (A) until it is clear of the disc and slide the arm
inboard off of bushing (B).
9.
Remove bushing halves (B). If required, remove the next
tine or plastic finger so the arm can slide off the bushing.
Refer to the following procedures as necessary:
•
Removing Plastic Fingers, page 227
•
Содержание D50
Страница 101: ...169441 89 Revision D 10 Tighten bolts B OPERATION ...
Страница 124: ......
Страница 295: ...topsoil moisture 83 types 80 weather and topography 83 WOT definition 19 INDEX ...
Страница 296: ......