![background image](http://html.mh-extra.com/html/macdon/d50/d50_operators-manual_685672237.webp)
169441
225
Revision D
ϭϬϰϬϭϬϰ
A
B
Figure 4.210: Reel Speed Sensor
4.
Adjust the clearance between sensor (A) and driven
sprocket (B) to 2
–
4 mm (0.08
–
0.16 in.) by bending the
support.
4.10.5
Reel Tines and Fingers
If a steel tine or plastic finger is damaged or worn, it will need to be removed so it can be replaced.
IMPORTANT:
Keep the reel tines and fingers in good condition. Straighten or replace them as required.
Removing Steel Tines
Damaged steel fingers will need to be cut off of the reel tine tube.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
IMPORTANT:
Ensure the tine tube is supported at all times to prevent damage to the tube and other components.
1.
Lower the header fully.
2.
Raise the reel fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
3.10.1 Engaging Reel Safety Props, page 36
5.
Remove the tine tube bushings from the applicable tine tube at the center and left reel discs. For instructions, refer to
4.10.6 Tine Tube Bushings, page 229
.
Содержание D50
Страница 101: ...169441 89 Revision D 10 Tighten bolts B OPERATION ...
Страница 124: ......
Страница 295: ...topsoil moisture 83 types 80 weather and topography 83 WOT definition 19 INDEX ...
Страница 296: ......