MacDon Industries Ltd.
680 Moray Street, Winnipeg, Manitoba, Canada R3J 3S3
T. (204) 885-5590 f. (204) 895-9146 www.macdon.com
215037
9
Revision B
U&A, Dealer
– C Series
i.
May consider completing step 10 before installing snouts.
ii.
Snout may need to be spread at the rear flanges to fit poly over bushings.
c.
Install wire brackets on front snouts (Figure 8). Brackets support snout in service position and can be
found in wooden shipping crate.
8.
Setting Header Angle
a.
Place combine harvester on level ground.
b.
To set header angle, lower header until front of row unit rest of a 4” X 4” block (Figure 9).
Figure 7: Snouts in shipping position (left), snout pivot hardware (circled, right).
Figure 9: Rest 4" x 4" block on front of row unit (arrow, left) and measure deck plate angle (arrow, right) relative
to ground.
Figure 8: Installation and function of front snout wire brackets.
