UNLOADING AND ASSEMBLY
Form 169078
Revision C
20
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT - M205 STD, M200, M150 AND
M100 OPTIONAL
1. Adjust the position of the center link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on
the GSL to position the hook above the
header attachment pin.
2. Lower the center link onto the header with
REEL UP switch, until it locks into position
(handle is “down”).
e. Raise the header fully with the HEADER UP
switch on the GSL. Stop engine, and remove
key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
f. Pull lever (A), and rotate “toward” header to
release and lower cylinder stop (B) onto
cylinder. Repeat for both lift cylinders.
g. Install pin (C) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (C) is fully inserted, and hairpin
is installed behind bracket.
(continued next page)
C
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
B
A
Содержание A30-D
Страница 53: ...NOTES Form 169078 Revision C 53 ...
Страница 55: ......