UNLOADING AND ASSEMBLY
Form 169078
Revision C
19
c. Slowly drive windrower forward so that feet (E)
enter boots (B) on the header. Continue to drive
slowly forward until feet engage the boots, and
header nudges forward.
d. Connect center link as follows:
MECHANICAL LINK - M100, M150
DANGER
Stop engine, and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
1. Stop engine, and remove key.
2. Loosen nut (F), and rotate barrel (G) to
adjust length so that other end “lines up”
with header bracket.
3. Install pin (H), and secure with cotter pins.
4. Adjust link to required length for proper
header angle by rotating barrel (G). Tighten
nut (F) against barrel. A slight tap with a
hammer is sufficient.
5. Proceed to step e.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT - M200 STD, M150 AND M100 OPTIONAL
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center link cylinder
so that the hook lines up with the header
attachment pin.
2. Stop engine, and remove key.
3. Re-locate the pin at the frame linkage as
required to position the hook over the
header pin.
4. Push “down” on rod end of link cylinder until
hook engages pin on header, and is locked.
5. Check that center link is locked onto header
by pulling “upward” on rod end of cylinder.
6. Proceed to step e.
(continued next page)
B
E
G
F
H
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
Содержание A30-D
Страница 53: ...NOTES Form 169078 Revision C 53 ...
Страница 55: ......