Mac allister MCSWP2000S-2, Руководство пользователя

Страница: 23 / 53

MCSWP2000S-2
22
EN
Getting
started...
Checking
NOTE: Perform the following test before operating your
product.
This product is equipped with an automatic oiling system.
The oiling system automatically delivers the proper amount
of oil to the bar and chain.
Checking the lubrication requires starting the product. Before
checking, the product must be fully assembled and all
instructions must have been read.
1. Check the chain lubrication before each use.
2. Make sure the guide bar (4) and the saw chain (3) are in place
when you check the oil delivery.
3. Switch on the product (see section “on/off switch” below); keep
pressing the on/off switch (17) and check if the chain oil is
delivered as shown in the figure (Fig. 14).
4. Have the chain oil flow adjusted by an authorised service centre
or similar qualified person if required.
Fig. 14
Connection to power supply
WARNING! Check the voltage! The voltage must comply
with the information on the rating label!
Always use a residual current supply (RCD) protected
supply! with a max. of 30mA release current.
If an extension cord is used, make sure the extension cord
is specifically designed for outdoor use and not lighter than
H07RN-F, 2x1.5mm² and max. 75m.
Before you start