Mac allister MCSWP2000S-2, Руководство пользователя

Страница: 19 / 53

MCSWP2000S-2
18
EN
Getting
started...
Before you start
5. Ensure the tension disc (23) is adjusted to inner right position,
turn anticlockwise if required (Figs. 3, 4).
6. Align the guide bar (4) and saw chain (3) assembly with the drive
sprocket (22) and support pin(21). Lay the saw chain around
the drive sprocket and then lower the guide bar to install it to the
support pin (Figs. 5, 6).
7. Make sure the saw chain (3) is properly placed into the groove
around the guide bar (4) before replacing the cover.
8. Replace the cover (9) and slightly tighten the locking wheel (7)
(Fig. 7, b). Do not tighten the locking wheel (7) completely; saw
chain tensioning is required first.
Fig. 3
Fig. 5
Fig. 7
Fig. 4
Fig. 6
23
7 9
NOTE: The saw chain (3) has not yet been tensioned.
Tension the chain as described under “Saw chain
tensioning”. After operating the product for approx. 1 hour,
adjust the chain tension again.
22
23
21
22