Mac allister 64 77 19, Оригинальное руководство пользователя

Страница: 32 / 116

32
GB
MSSP120
In
more
detail...
Operation
• Then, first loosen the upper blade clamping screw (Figure 7.2, H), and then
the lower clamping screw with an Allen key.
• Inserting the saw-blade
• Fix the blade first in the lower clamp. To fix the blade, securely tighten the
blade clamping screw (Figure 7.2, H) with an Allen key.
• Press the upper arm of the saw slightly downwards (Fig. 6) and fasten the
other end of the saw blade in the upper clamp.
• Tighten the blade with the clamping lever (Fig. 7.3) by pressing it down
again. Check the tension of the blade. If the tension is too low, increase it by
turning clockwise. First slacken the clamping lever again.
• Insert the table insert.
B Saw-blade with pins
• Saw blade removal, fig. 6,7
• To remove the saw blade, lift the table insert upwards
• Ease the tension with the clamping lever (fig. 7.1, 1).
• Remove the saw­blade from the upper and lower support by slightly pres­
sing the saw´s upper arm down (fig. 6).
• Inserting the saw-blade fig 6-11
• Lead one end of the saw­blade through the perforation in the table and
insert the saw­blade pins into the notch. Repeat this procedure at the upper
blade support.
• Before hooking it in, slightly press the saw´s upper arm down. (Fig. 6)
• Check the position of the blade pins at the supports.
Fig. 6

Fig. 7.1
1
Fig. 7.2
H

Fig. 7.3
1