Starting Up:
1.-
2.-
3.-
Removal of Ice
1.-
2.-
Smart Fill Ice Factory (only available with certain models)
72
NOTE: It’s important that once you have completed the above steps you make
sure that the water cylinder is correctly installed to prevent water freezing in
the cylinder’s interior.
NOTE: The cylinder can only hold one load at a time. Before repeating the
process, make sure that the tray is empty.
NOTE: The ice produced may vary in size.
This no-spill ice-maker with removable cylinder feeds directly into the
ice-tray. It comes with a storage box that can hold up to 900g of ice.
Remove the water cylinder found at the top of the SMART FILL
ICE FACTORY (SFIF) by pulling the top middle part towards you.
Put the cylinder back in its original position making sure it’s
securely connected. You should be able to see and hear the
water filling the ice-tray which indicates that the cylinder is
correctly installed.
After a while, your ice cubes will be ready for use. To remove
them, pull the handle slowly towards you until it’s fully down. At
this point it will be necessary to pull the handle a little more
forcefully until you hear the ice fall into the lower compartment
of your SMART FILL ICE FACTORY.
This compartment can hold up 3 complete
releases of the ice-tray. To remove the ice, simply lift and pull the
storage box that you will find in the lower part. This box is
designed to be brought wherever you wish.
To make more ice, repeat the process.
Once removed, place the water cylinder on a flat surface. Open
the top, which you’ll find in the middle centre. To avoid
spillages, make sure that there’s no residual ice obstructing the
valve of the cylinder before you fill it with water. Pour 180 ml of
purified water into the cylinder or fill it to the maximum level.
Replace the top, placing pressure on the middle. It’s essential
that it’s secure in the centre in order to avoid water leaking out.
