MAAX 2007 Elite spas, Руководство пользователя, Страница: 29 / 48

29
Changing Filter Cycles
The 760 Series Control systems allows you to
adjust the start time and duration of each filter cycle
independently to best suit your schedule. The amount
of time needed to filter your sap will vary depending
upon usage and ambient conditions, but a total filter
time of at least four hours per day is recommended to
properly clean and maintain the water.
If you are setting the filter cycles as a continuance
from setting the time then proceed to the next
paragraph. To initiate the programming sequence to
change the filter cycles, press
TIME, MODE/PROG,
MODE/PROG, and MODE/PROG within 3 seconds.
You should now see the “PROGRAM”, “FILTER
1”, and “START TIME” icons on the LCD display
window. The hour digit(s) will be flashing on the
LCD window. Press the
SET UP or SET DOWN
button to advance the hours up or down to choose the
Filter 1 start hour. Enter the hour by pressing the
MODE/PROG button. The minute digits will now be
flashing on the LCD window. Press the SET UP or
SET DOWN button to advance the minutes up or
down, in 5 minute increments, to choose the Filter 1
start time. Enter the minutes by pressing the
MODE/PROG button.
You should now see the “PROGRAM”, “FILTER
1”, and “END TIME” icons on the LCD display
window. Adjust the hours and minutes for the end
time of the first filter cycle as described above.
After pressing the
MODE/PROG button to enter the
end time of the first filter cycle, you should now see
the “PROGRAM”, “FILTER 2”, and “START TIME”
icons on the LCD display window. Adjust the hours
and minutes for the start time of the second filter cycle
as described above.
After pressing the MODE/PROG button to enter
the start time of the second filter cycle, you should
now see the “PROGRAM”, “FILTER 2”, and “END
TIME” icons on the LCD display window. Adjust the
hours and minutes for the start time of the second filter
cycle as described above.
After pressing the MODE/PROG button to enter
the end time of the second filter cycle, the new
filtration times will be saved into the system and the
LCD window will revert back to display the current
water temperature.
Pressing
the
TIME
button at any time during the
above programming sequence will save the values
entered up to that point and exit the programming
sequence.
To set the spa for continuous filtration, set the start
and end times of the first filter cycle to the exact same
time.
Clean Up Cycle
After periods of heavy use, you can manually
start a clean-up cycle by turning Pump 1 on in low
speed. The pump will operate for 2 hours and then
automatically turn off. The heater will also operate
during this period if the controls are set in the Standard
mode.
Light
Accessing Different Light Modes
To change modes, press the LIGHT button off
and on within 5 seconds. The light will advance to the
next color sequence mode. Continue this process until
the desired color sequence mode is selected.
Therapy Sequencer
Certain models are equipped with a Jet
Sequencer System that opens and closes a series of
four solenoid valves to provide a therapeutic
sequencing massage. The control panel for the system
allows you to start or stop operation, change programs,
change speeds, or pause the system at any point in the
program.