Digital
Digital
Digital
Digital
Digital DDDDDimmer
immer
immer
immer
immer
eMail: [email protected] . Tel.: + 49 9 31 49 79 40 . User's Manual Digital Dimmer
99999
4.4 The Setup Menu (Supervisor Menu)
This menu can be reached only by pressing the menu button (middle button) for a minimum of
5 seconds. In this menu very important parameters can be controlled .
Attention!
In this menu drastic changes can be made, which can alter the function
of the dimmer considerably (e.g. delete all).
Controlling this menu: Turning the encoder selects the line, pressing the right button and simultane-
ously turning the encoder selects different functions or starts them.
All functions are permanently stored when the menu is left.
4.4.1 DMX Fail (reaction when DMX signal stops)
Here the reaction to failing DMX signal can be programmed.
-HOLD:
holds the last received DMX signal until a new DMX signal reaches the dimmer.
-OFF:
holds the last received DMX signal for 1 second and then switches off.
Com.: The analogue input (0...10 Volt) will be switched off, when a valid DMX
signal is received.
-CHA 1s:
starts the internal chase after waiting for 1 second (see 4.3).
-M1 1s:
calls internal memory no.1 after waiting for 1 second.
-M2 1s:
calls internal memory no.1 after waiting for 1 second.
-M3 1s:
etc. etc.
-CHA 9s:
starts the internal chase after waiting for 9 second´s.
-M1 9s:
calls internal memory no.1 after waiting for 9 second´s.
-M2 9s:
etc. etc.
The actual status will be displayed in the Top Menu (message: "NO DMX M01")
4.4.2 DMX MODE (different DMX operating modes)
Here "Block", "Single" and "2Cha." can be selected.
-Single
means, that every dimmer channel can be patched to a freely selectable DMX address
(Single-Mode, free patching).
-Block
means, that the complete dimmer (12 channels) has only one start address (Block
Mode). Starting with the first dimmer channel, every next channel has a DMX address
which is one number higher. The "Block" mode is the standard mode (default).
-2 Cha.
means, that the 2-channel switch-mode is active. This mode is necessary, if only
2 single DMX channels control all 12 dimmer channels (switch on and off).
This method economizes a lot of DMX channels.
Mode of operation: The first DMX channel switches exactly 64 different combinations
of dimmer no. 1...6 on and off depending on its value. The "Binary principle" is used.
The 2nd DMX channel controls the dimmer channels 6...12.
Examples and a table can be found in the appendix of this manual.
Содержание Digital Dimmer
Страница 1: ...Digital Dimmer User s Manual Version 1 40...
