Digital
Digital
Digital
Digital
Digital DDDDDimmer
immer
immer
immer
immer
eMail: [email protected] . Tel.: + 49 9 31 49 79 40 . User's Manual Digital Dimmer
77777
4.2 The Channel Menu (2nd Menu)
This menu always appears after the Top Menu when the middle button (Menu) is pressed.
Here for every channel the DMX address, a control curve, the limitation, the preheat of the lamps and
the loadcheck is programmed .
Procedure: The encoder selects one channel (1...12). In the display the cursor is moving up and down
(vertically).
When the left button is pressed the encoder now works in the horizontal direction (left/right). Now "DMX
address", "Curve", "Limit" etc. can be selected. The actual value is displayed inversely. So a good
orientation is always ensured.
When the right button is pressed and the encoder turned simultaneously the actual value (e.g. DMX
address, Switch, ...) can be changed.
Menu button leads to the 3rd menu
(Memory menu)
Exception: When the Dimmer is just
working in "normal user" mode, the
button switches back to the Top
menu.
Encoder preselects channel 1-12
(without pressing any button).
Pressing the left button and simultaneously
turning the Encoder selects DMX, Curve,
Limit etc.
1 100%
No DMX CUR LIM PRE LC
1
1 -
100
-
2
2 -
100
-
E
3
3 -
100
-
4
4 Cu1 100
-
5
5 -
100
-
6
6 Cu2 100
-
7
7 S w i 100
-
8
8
-
60
5
9
9 -
100
-
10
10 -
100
-
11
11 -
100
-
12
12 -
100
-
Selected Channel
(Encoder)
DMX address for channel 3
Control curve "linear "
Control curve "Curve 2"
Control curve "Switch"
Channel 8 limited to 60%,
all others have no limit (100%)
Preheat set to 5%
Information from the Top menu:
(load connected, o.k.)
Information from the Top menu:
When no load is connected an "E" is
indicated and the red LED´s lit, to show
a "Loadcheck-Error" .
Loadcheck is switched off
(small rectangle); no red LED indication
Loadcheck is switched on
(large rectangle). When no load is
connected an "E" is indicated and the red
LED´s lit, to show an "Loadcheck error" .
Holding this button allows to program
the parameters of the selected channel
(1); by turning the encoder at the same
time (e.g. the DMX address).
In the left button appears "SET ALL" (not
at DMX). By pressing both buttons
simultaneously, all channels will be set
to the same value.
Attention!
These settings will be stored permanently
when a new channel is selected or the
menu is changed.
Содержание Digital Dimmer
Страница 1: ...Digital Dimmer User s Manual Version 1 40...
