K11-R sealing unit
68
IDM 510-065-1
English language
Operation and maintenance manual
▀
Upper sealing unit (flap 50 mm)
1.
Remove the adhesive tape from the
sealing unit.
2.
Components
A-C
must be installed
as shown in the figure.
3.
Apply tape stretcher to the adhesive
side of the tape.
4.
Guide tape stretcher until the tape
stretcher is beyond the point of tan-
gency of case inlet roller.
5.
Cut the adhesive tape close to tape
stretcher.
The part of exceeding adhesive tape
must not be lower than the flap
length.
–
Request components B in order to
obtain a 70 mm flap.
–
To obtain a 30 mm flap, request
component D and replace to the
one installed.
▀
Lower sealing unit (flap 50
mm)
1.
Lift upper conveyor completely.
This operation is necessary to assist the operations.
2.
Remove lower sealing unit
– Repeat the operation according to the procedure described for upper sealing unit.
3.
Insert sealing unit into its original housing.
