M Design LUNA Series, Инструкция по установке и эксплуатации

Страница: 29 / 45

3
1
2
Passion for fire
4
29
1 2
3 4
Instructions for installation and use TRUE VISION Gas
In case you want to go to a thermostatic control, you follow the next steps:
Press 2x the button until you see the screen with the symbols shown in picture 2.
Press or until the symbols and are blinking (pic 2).
Confirm your choise by pressing ( pic.3).
Choose a temperature with the “up” and “down” arrows (pic. 4).
Don’t place the remote control near the fire. The temperature sensor is in the remote
control. To get back to manual control do the smame until and are blinking.
Confirm with
4. Thermostatic control
To light up the side burners 2, press .
First you see the wave settings (page 30). or
Press a second time and you will see a “b0” or “b0”
If “b0” appears, press to “b1”, side burners 2 lights up.
If “b1” appaers, press to “b0” , side burners 2 will go out.
Choose a flame height from 1 to 15 by pressing or
To switch off the entire stove press
Remark: If after a previous use of the fireplace, you turned it off in “b1” mode,
next ignition, the burners 1,2 and 3 will light simultaneously. If, on the other hand, you have
switched off the appliance in mode “b0” the appliance will switch on only with the burner 1
3. Manual control (continuation)