M Design LUNA Series, Инструкция по установке и эксплуатации

Страница: 14 / 45

1/2 0 1
14
Instructions for installation and use TRUE VISION Gas
5. Flame adjustment settings
After installing the fireplace correctly on the concentric tube or chimney system, you can make any
adjustment on the flame. The air intake can be adjusted more or less.
By removing the wand, a small lever is located at the bottom left in the corner under the glass.
Bleu flames (not enough oxygen), move the level to the right : position 1
Flames instable (“nervous” flames), move the level to the left : position 0
(open)
(closed)
6. Insulation and finishing
Once installation is complete, the appliance can be fitted. Before doing so, check the
tightness of the gas pipe one more time. Light the appliance and check that it is wor-
king: check the tightness of the gas pipe and the smoke pipe. Once you have checked
everything, you can perform the final insulating and finishing operations.
The built-in part of the appliance tends to be very warm. Please check that the ap-
pliance is not too narrowly fitted and that there is adequate space for the elimination
of hot air. For insulation of the appliance, we advise you to use M Design insulating
plates. You are advised against using any other insulation product. Inflammable mate-
rials as well may not be used for the finishing.
Please , follow this instruction. The appliance can overheat if you do not fol-
low these instructions. Errorcode F02 will appear !
Masonry must be raised around the fireplace. Due to the expansion
of the fireplace during combustion, a gap of at least 5 mm must be
provided at the front of the fireplace and 4 cm on each side of the
appliance. The masonry must not rest on the fireplace. THE FIRE-
PLACE MUST BE FREE. Always leave 2 mm clearance between the
inner frame and the masonry.