M-B MSV, Руководство по техническому обслуживанию и ремонту

Страница: 245 / 427

J1587
FAULT
CODE
{ LAMP}
PIDn
SID S
(FMI }
J1939
SPN(S)
(FMI} REASON
EFFECT
778
(Amber}
S064
{2}
723
{2} Engine can run rough. Possibly poor starting capa-
bility. Engine runs using primary engine position
sensor.
Engine Camshaft Speed/Position Sensor - Data Er-
ratic, Intermittent, or Incorrect. The ECM has de- tected
an error in the camshaft position sensor sig- nal.
Possible engine derate.
779
(Amber}
S051
( 11}
703
{11} Auxiliary Equipment Sensor Input 3 - Root Cause Not
Known
784
{None}
S145
(2)
1590
{2} Adaptive cruise control will
not
operate. Standard
cruise control may
not
operate.
Adaptive Cruise Control Mode - Data Erratic, Inter-
mitten!, or Incorrect. Loss of communication with
adaptive cruise control.
1117
{ None)
S251
{2} 627
{2}
Possible no noticeable performance effects or en- gine
dying or hard starting. Fault information, trip
information, and maintenance monitor data can be
inaccurate.
Power Supply Lost With Ignition On - Data Erratic,
Intermittent, or Incorrect. Supply voltage to the ECM
fell below 6.2 volts momentarily or the ECM was
not
allowed to power down correctly (retain battery
voltage for 30 seconds after key OFF).
Accelerator Pedal or Lever Position Sensor 2 Circuit Severe derate in power output of the engine. Limp
1239
{Amber}
None
{3}
2623
{3}
home power
only.
- Voltage Above Normal or Shorted to High Source.
High voltage detected at accelerator pedal position
number 2 signal circuit.
Accelerator Pedal or Lever Position Sensor 2 Circuit Severe derate in power output of the engine. Limp
1241
{Amber}
None
{41
2623
{4}
home power
only.
- Voltage Below Normal or Shorted to Low Source. Low
voltage detected at accelerator pedal position number
2 signal circuit.
The engine will
only
idle.
1242
(Red}
P091
{2}
91
{2) Accelerator Pedal or Lever Positidn Sensor 1 and 2
- Data Erratic, Intermittent, or Incorrect. Accelerator
position sensor number 1 and number 2 are read- 1ng
different values.
1663
{Amber}
S326
( 111
3241
{31}
Active aftertreatment diesel particulate filter regen-
eration will be disabled.
Catalyst Inlet Temperature Sensor Swapped with Outlet
- Condition Exists. The inlet and outlet cata- lyst
temperature sensor connections are swapped.
1664
{Amber}
None
{11}
3050
{31}
Catalyst Missing - Condition Exists. The aftertreat- Active aftertreatment diesel particulate filter regen-
ment catalyst in the exhaust system is
not
present. eration will be disabled.
Aftertreatment Exhaust Gas Temperature 1 Circuit · Active aftertreatment diesel particulate filter regen-
1665
{Amber}
S326
{4}
3241
{4}
eration
will
be disabled.
Voltage Below Normal or Shorted to Low Source.
Low signal voltage detected at the catalyst inlet
sensor circuit.
1666
{Amber)
S326
{3)
3241
(3}
Active aftertreatment diesel particulate filter regen-
eration will be disabled.
Aftertreatment Exhaust Gas Temperature 1 Circuit -
Voltage Above Normal or Shorted to High Source. High
signal voltage detected at the catalyst inlet temperature
sensor circuit.
1667
(Amber}
S326
{2}
3241
{2)
Active aftertreatment diesel particulate filter regen-
eration will be disabled.
Aftertreatment Exhaust Gas Temperature 1 - Data
Erratic, Intermittent, or Incorrect. The aftertreatment
diesel oxidation catalyst inlet temperature sensor is
not
changing with engine operating conditions.
1674
(Amber}
S327
{4} 3249
{4}
Active aftertreatment diesel particulate filter regen-
eration will be disabled.
Aftertreatment Exhaust Gas Temperature 2 Circuit -
Voltage Below Normal or Shorted to Low Source.
Low signal voltage detected at the aftertreatment
diesel particulate filter inlet temperature sensor cir- cuit.
1675
(Amber}
S327
{3} 3249
{3}
Active aftertreatment diesel particulate filter regen-
eration will be disabled.
Aftertreatment Exhaust Gas Temperature 2 Circuit -
Voltage Above Normal or Shorted to High Source. High
signal voltage detected at the aftertreatment diesel
particulate filter inlet temperature sensor cir-
Aftertreatment Exhaust Gas Temperature 2 - Data
cuit.
Active aftertreatment diesel particulate filter regen-
1676
{Amber}
S327
{2} 3249
{21
Erratic, Intermittent, or Incorrect. The aftertreatment eration will be disabled.
diesel particulate filter inlet temperature sensor is
not
changing with engine operating conditions.
None on performance.
1691
(Amber}
None
(13}
3050
{13}
Catalyst Efficiency - Out of Calibration. The tam-
perature increase across the aftertreatment diesel
oxidation catalyst is lower than expected.
1695
{Amber}
S232
{3}
3513
{3}
Severe derate in power output of the engine. Limp
home power
only.
Sensor Supply 5 - Voltage Above Normal or
Shorted to High Source. High voltage detected at
sensor supply number 5 circuit in the OEM har-
ness.
1696
{Amber}
S232
{4}
3513
(4}
Severe derate in power output of the engine. Limp
home power
only.
Sensor Supply 5 • Voltage Below Normal or Shorted
to Low Source. Low voltage detected at sensor
supply number 5 circuit in the OEM har-
ness.
P101
101
No engine protection for high crankcase pressure.
1843
{Amber}
{3} {3}
Crankcase Pressure Circuit - Voltage Above Normal or
Shorted to High Source. High signal voltage de- tected at
the crankcase pressure circuit.
No engine protection for high crankcase pressure.
1844
{ Amber}
P101
101
{4} {4}
Crankcase Pressure Circuit - Voltage Below Normal or
Shorted to Low Source. Low signal voltage de- tected at
the crankcase pressure circuit.