Pressing the needed button only once will send the program and bank change
instructions during performance as described earlier.
Please refer to the below examples to see how this operation works. Also, refer to the
chart in Appendix B for complete information.
Assigning MMC Control to a Button
1. Select the button you want to control the MMC message.
2. Press the CONTROL ASSIGN button on the Keystation Pro 88.
3. Type in “149” using the numerical keypad. 149 is the number that corresponds to the
MMC instruction, as per the chart in Appendix B.
4. Press the CHANNEL ASSIGN button once.
5. Type in “127” using the numerical keypad. This ensures that the message is set to
all device ID numbers. For more information about this, please read “About SysEx
Messages and Device ID” in the “Programming and Editing” section of this manual.
6. Press the DATA LSB button twice.
7. Enter a number from the following chart to select the MMC message you want:
Assigning RPN/NRPN to a Fader/Rotary Controller
1. Press CONTROL SELECT (GLOBAL CHANNEL + CHANNEL ASSIGN) and move
the desired controller.
2. Press the CONTROL ASSIGN button twice and, with the display flashing, enter
controller 132 for RPN coarse, 133 for RPN fine, 134 for NRPN coarse or 135 for
NRPN fine.
Содержание Keystation Pro 88
