Lynx LHEM48, Руководство по эксплуатации и установке

Страница: 21 / 36

CARE & USE/INSTALLATION
|
21
When the heater is operated for the first time, there may be
a certain level of smoke exiting the heater exhaust vents.
This may last for up to 15 minutes. This is NORMAL. This is
a result of the manufacturing oils, cleaning oils, and anti-
seize lubricants, burning away under high temperature for
the first time. After this ‘break-in’ period, your heater should
function normally, emitting no additional smoke.
TOUCH SCREEN REMOTE CONTROL OPERATION
Before attempting to operate your remote, you must be
sure that the remote control has been ‘initialized’ or paired
with the receiver. Please see the section of this manual
titled ‘Initializing the Remote Control System’ Page 19.
CHANGING FROM FAHRENHEIT TO CELSIUS
When the remote control is OFF, the current air
temperature is displayed in the upper right hand corner of
the display window. This temperature will read in degrees
Fahrenheit (F) or degrees Celsius (C). To alternate and
change between degrees (F) and degrees (C), with the
remote in the OFF position, simply press the DOWN arrow
key and the UP arrow key at the same time briefly. Use a
short click and do not hold the buttons down continuously.
Please refer to the diagram ‘Touch Screen Remote Control
Layout’ Page 22, for reference
DAY AND TIME DISPLAY
• The current day of week and time of day will be
continuously displayed in the TIME/PROG Zone
(except during Setup operations).
• The day of week will be displayed as one of the
following: S, M, T, W, T, F, S
• The time of day will be in 12-hour AM, 12-hour PM
format. Midnight will be displayed as 12:00am.
• Day/Time Setup-Turn Operation Mode to OFF By
pressing the MODE/ SET button at bottom:
• Press and hold the MODE Zone or the MODE/SET
Button for 5 seconds to enter Day/Time Setup.
• Press the UP or DOWN Buttons to adjust the day
of week (press the MODE/SET Button or wait for 15
seconds for adjustment to be accepted, then enter
hour of day adjustment).
• Press the UP or DOWN Buttons to adjust the hour of
the day. The time will advance in 1-hour increments;
AM and PM will change when the hour advances to
12:00 midnight and 12:00 noon respectively (press
the MODE/SET Button or wait for 15 seconds for
adjustment to be accepted, then enter minute of hour
adjustment).
• Press the UP or DOWN Buttons to adjust the minute
of the hour. The time will advance in 1-minute
increments (press the MODE/SET Button or wait for 15
seconds and the transmitter will exit Day/Time Setup
and return to normal operation).
• LCD Displays – when in Day/Time Setup:
• MODE Zone: Blank
• ROOM/AIR TEMP Zone: Blank
• SET TEMP Zone: Bank
• LIGHT Zone: Blank
• FAN Zone: Blank
• TIME/PROG Zone: Day of Week, or Time of Day will
Flash
• AUX Zone: Blank
• FLAME Zone: Blank
PROGRAMMING YOUR REMOTE...
continued