Source
Target
NOTE:
Group number (1-6) buttons
will flash twice on the initial press
of Reset button, then again at six
seconds . Target remote now ready
to receive information from source
remote .
Target
Source
Source
Target
NOTE:
Group numbers on target
remote will flash twice to indicate it
has been networked to the source
remote .
NOTE:
If NO shades have been
joined to a group number
(1-6) on a remote, choose
any remote to be the Source
remote . Otherwise, choose
the remote that was used to
program/operate shade(s) to
be the Source remote . A target
remote receives information
from the source remote .
1
1
4
5
2
3
1
[ 6 ]
[ 7 ]
Press and Hold
n
(Stop)
on remote
until indicator lights blink .
(approximately 6 seconds)
Programming Mode
Programming Mode is required to perform key remote related programming procedures . In programming mode,
you can set a variety of functions, from joining a shade to a Group number (1-6) on a remote to removing a shade
from a Group number (1-6), to setting Favorite shade positions . You must activate programming mode on the
PowerView® Pebble® Remote to establish communication between the remote and shade .
Enter Programming Mode
Exit Programming Mode
Press and Hold
n
(Stop)
on remote
until indicator lights stop blinking .
(approximately 6 seconds)
NOTE:
Programming mode automatically times out at 20 seconds . Programming mode extends by an additional 20 seconds
simply by pressing any button on the remote .
Simultaneously. . .
PRESS
and
RELEASE
n
(Stop)
on source
remote .
RELEASE (Stop)
on target remote .
Using a paper clip,
PRESS
and
HOLD
recessed Reset button
on back of
target remote for
6-10 seconds
. If
necessary, remove back cover .
PRESS
and
CONTINUE TO HOLD
n
(Stop)
on target remote .
On source remote,
PRESS
and
HOLD
n
(Stop)
until indicator lights begin
to blink . Source remote is now in
Programming Mode .
SELECT
a
source
and a
target(s)
remote .
Pairing Remotes
Each PowerView® Remote comes with its own unique Radio Frequency (Network) ID . If multiple
remotes (ie . PowerView® Pebble® and/or PowerView® Surface Remotes) will be used in the home,
PAIR ALL REMOTES BEFORE JOINING ANY WINDOW COVERING TO GROUP NUMBER(S) (1-6)
ON ANY REMOTE.
This is done to ensure that if a PowerView® Hub or PowerView® Repeater(s) is to
be used in the future, it can operate previously programmed window coverings in the home and be
used in conjunction with all the remotes on a single, unified PowerView® Shade Network . Otherwise,
some window coverings will be unresponsive to commands sent from the Hub or Repeaters .
RELATED TOPICS
RELATED TOPICS