4. Adjust the currently selected EDU to the desired level,
using the Raise (
) and Lower (
) buttons on the
Keypad.
6
Setting Limits
Note:
Entering Limit Setup mode may cause the
window treatments to move approximately 200 mm
(8 in) up or down.
Be sure that each window
treatment is positioned such that the fabric can safely
move approximately 200 mm (8 in) before entering
Limit Setup mode.
Note:
When using Keypads that do not have Raise and Lower
buttons, set the limits at the EDU. Refer to the
Sivoia QED
Wiring and Programming Guide for more information.
1. If using the SQE-33, select the group you wish to assign.
2. Enter Limit Setup mode by pressing and holding the Open
(
) and Raise (
) buttons simultaneously for 5 seconds.
The LED next to the Open (
) button will flash once per
second and the LED next to the Close (
) button will flash
quickly (8 times per second).
3. Select the EDU to adjust using the Open (
) button on the
Keypad. Each time the Open (
) button is tapped, an EDU
will begin opening and closing over a range of
approximately 200 mm (8 in). Repeat tapping the Open (
)
button until the desired EDU is selected. The Close (
)
button can also be used to select EDUs by moving through
the EDUs in the opposite order.
5. Store the current position as the Open (
) limit by
pressing and holding the Open (
) button on the Keypad
for 5 seconds. The LED next to the Open (
) button will
turn on for two seconds.
OR
Store the current position as the Close (
) limit by
pressing and holding the Close (
) button on the Keypad
for 5 seconds. The LED next to the Close (
) button will
turn on for two seconds.
6. Use the Open (
) or Close (
) buttons to select other
window treatments and adjust the limits as in Steps 3 and
4.
7. Exit Limit Set mode by pressing and holding the Open (
)
and Raise (
) buttons simultaneously for 5 seconds.
Installation Instructions
Occupant Copy
LED on for 2
seconds
Press & hold
here to set the
Open (
) limit
Press the Open (
)
and Raise (
) buttons
simultaneously for 5
seconds.
LED flashing once
per second
LED flashing 8 times
per second
Press the Raise (
) or
Lower (
) button.
LED on for 2
seconds
Press & hold
here to set the
Close (
) limit
