5
Occupant Copy
Installation Instructions
5. Remove the faceplate from the Keypad. To remove the
faceplate, pull outward at each corner, one corner at a
time.
6. Mount Keypad as shown in the diagram below.
7. Attach faceplate by pressing in at each corner, one corner
at a time.
Thread all four screws before tightening.
Wallbox
Wall
Mounting Frame Orientation
Wallbox
Mounting
Frame
Carrier
Faceplate
Mounting
Frame
Addressing the System
Note:
For the SQE-RL, use the
and
buttons instead of
the and buttons.
1. Enter programming mode on the Keypad by pressing and
holding the Open (
) and Close (
) buttons
simultaneously for 5 seconds. The LEDs next to the Open
(
) and Close (
) buttons will flash once per second,
indicating the Keypad is in Programming mode.
2. Initiate system addressing by tapping the Open (
) button.
The LED next to the Open (
) button will flash quickly (8
times a second) and the LED next to the Close (
) button
will turn off. The system is now being automatically
addressed.
Press the Open (
) and
Close (
) buttons
simultaneously for 5
seconds.
Flashing
once per
second
3. Wait for system addressing to be completed. This will take
approximately one minute. While addressing is in progress,
each Keypad will flash the Open (
) LED quickly (8 times
a second). When addressing has successfully completed,
the Open (
) and Close (
) LEDs on each Keypad in the
system will flash slowly (once per second).
4. When system addressing is complete, exit Programming
mode by pressing and holding the Open (
) and Close
(
) buttons simultaneously for 5 seconds. The Open (
)
and Close (
) LEDs will stop flashing.
Tap the Open (
)
button.
Flashing 8
times per
second
