B
C
A
B
C
A
1
1
2
3
Page 6
Sivoia QS Drapery System Installation Guide
5
Pinch Pleat Fabric Installation
continued
5.5 Add or remove auxiliary carriers - center draw systems:
5.6 Dressing the drapery around the drive end:
A. Follow the instructions in section 5.3 for the drive end plug removal, and installation of the
auxiliary carriers.
B. Remove the screw that retains the idler end cover. Remove the idler end cover and the hook eye.
C. Insert or remove auxiliary carriers through the square hole in the idler end cap until the desired
number of carriers is installed.
D. Install the idler end hook eye and replace the idler end cover using the screw removed in step B.
Drapery fabric
Adjustment of the drapery pin height may be necessary to
align these pleats with the other pleats on the drapery panel.
Left and right draw
single track systems
(right draw shown)
Master Carrier
Auxiliary Carriers
Idler End Cover
Auxiliary
Carrier
Drive End
Railbox hooks
for last two (2)
drapery hooks
Idle End
5.4 Hang the drapery - center draw systems:
A. Drive End:
Attach the drapery to the drapery track
starting with the Master Carrier. Finish by attaching
the last two hooks of the drapery to the railbox
hooks.
B. Idle End:
Attach the drapery to the drapery track
starting with the Master Carrier. Finish by attaching
the last hook of the drapery to the idler end hook.
Remove any unused auxiliary carriers as shown in
the following section.
Center draw
single track systems
Master Carrier
Auxiliary Carriers
Drive End
Railbox hooks
for last two (2)
drapery hooks
Idle End
5.2 Hang the drapery - left and right draw systems:
Attach the drapery to the drapery track starting
with the Master Carrier, attaching the last two
hooks of the drapery to the railbox hooks.
5.3 Add or remove auxiliary carriers - left and right draw systems:
A. Remove square plug on the drive end of the track, using a flat blade screw driver.
B. Insert or remove auxiliary carriers through
the square hole in the track until the correct
number of carriers are installed.
C. Replace the square plastic plug by pushing it
into the square hole until it snaps into place.
