Sivoia QS Drapery System Installation Guide
Page 5
4
Electronic Drive Unit (EDU) Installation
4.1 Insert:
A. Insert the EDU mounting flange into
the rail box by aligning the mounting
tabs and drive shafts.
B. Push the EDU into the railbox until the
mounting tabs are fully inserted.
4.4 Basic Wiring:
•
For basic wiring instructions, please refer to the included wiring and setup guide:
045520 Sivoia QS Basic Wiring & Setup
•
For wireless receiver installation and setup, if applicable, please refer to the setup guide packaged with the wireless receiver:
045588 Sivoia QS Wireless RF Wireless Receiver
4.2 Rotate:
Rotate the EDU inside the mounting
flange and align the holes for the
securing screw. Ensure the wire
harness is not pinched.
4.3 Secure:
Install the securing screw.
NOTE:
The securing screw is
necessary to safely secure the EDU.
Verify that it is installed and tightened
before operating the drapery.
Rail Box
Mounting
Tabs
Drive
Shaft
EDU
5
Pinch Pleat Fabric Installation
5.1 Attaching hooks:
Lutron recommends a drapery hook setting of 1/2 in (13 mm) from the top of the drapery to the top of the hook (hooks not
included). This locates the drapes just below the track and prevents it from rubbing on the track. It is recommended that a
distance of 1/2-1 in (13-25 mm) be maintained between the bottom of drapery panel and the floor.
1/2 in (13 mm)
Top of drapery panel
Floor
Bottom of
drapery track
5/8 in
(16 mm)
1/2-1 in (13-25 mm)
Bottom of
drapery panel
Drapery
panel
5/8-
1 1/8 in
(16-29
mm)
